[Bug 300] Mechanical quality of Power button and AUX button

bugzilla-daemon at bugzilla.openmoko.org bugzilla-daemon at bugzilla.openmoko.org
Mon Mar 26 16:53:23 CEST 2007


http://bugzilla.openmoko.org/cgi-bin/bugzilla/show_bug.cgi?id=300





------- Additional Comments From laforge at openmoko.org  2007-03-26 16:53 -------
Those are actually two separate issues:

1) the button itself (the device soldered on the PCB) was not able to cope with
the reflow soldering temperature profile used by FIC - despite claims of the
manufacturer.  GTA01Bv4 will use higher quality buttons

2) apparently, for completely unknown reasons, somebody very early in the
project wrote a mechanical spec that said "the second button must be protected
against accidental button presses".  Until I managed to dig this out last week,
nobody seemed to remember this :(

Since this is now known, I'm sure new plastic buttons will be produced shortly
to fix this. Not sure if it will be before GTA01Bv4, though :(



------- You are receiving this mail because: -------
You are the assignee for the bug, or are watching the assignee.




More information about the buglog mailing list