[Bug 300] Mechanical quality of Power button and AUX button
bugzilla-daemon at bugzilla.openmoko.org
bugzilla-daemon at bugzilla.openmoko.org
Mon Mar 26 16:53:24 CEST 2007
http://bugzilla.openmoko.org/cgi-bin/bugzilla/show_bug.cgi?id=300
------- Additional Comments From laforge at openmoko.org 2007-03-26 16:53 -------
Those are actually two separate issues:
1) the button itself (the device soldered on the PCB) was not able to cope with
the reflow soldering temperature profile used by FIC - despite claims of the
manufacturer. GTA01Bv4 will use higher quality buttons
2) apparently, for completely unknown reasons, somebody very early in the
project wrote a mechanical spec that said "the second button must be protected
against accidental button presses". Until I managed to dig this out last week,
nobody seemed to remember this :(
Since this is now known, I'm sure new plastic buttons will be produced shortly
to fix this. Not sure if it will be before GTA01Bv4, though :(
------- You are receiving this mail because: -------
You reported the bug, or are watching the reporter.
More information about the buglog
mailing list