accellerometer test

Crane, Matthew mcrane03 at
Thu Apr 3 16:31:13 CEST 2008

I notice you mention only one chip is currently working as isr source.
But isn't there two independently configurable pins connected to irqs
from that one chip?  I didn't dig into the schematic, not sure.  


-----Original Message-----
From: openmoko-devel-bounces at
[mailto:openmoko-devel-bounces at] On Behalf Of Michael
'Mickey' Lauer
Sent: Thursday, April 03, 2008 10:08 AM
To: Andy Green
Cc: List for Openmoko community discussion;
openmoko-devel at
Subject: Re: accellerometer test

> It seems to me there is basically one number you can set, and then you
> can decide if X, Y and/or Z go above or below that number makes an
> interrupt.  It looks like this number is absolute, ie, if you set it
> 5 then going above or below 5 x 18mG "in + or -" will trigger it.
> So you can almost get what you are looking for, just that there is
> one number allowed.

Excellent! When do you have time to give that a go? :)



More information about the community mailing list