Using qi and booting from SD-cart
Andy Green
andy at openmoko.com
Wed Dec 17 21:52:50 CET 2008
-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1
Somebody in the thread at some point said:
| Hello,
|
| I'm using qi-s3c2442-master_2ad3ce6ff57753e3.udfu
| 01-Dec-2008 02:23 26K
|
| and a sd card (came with FR 512) with ext3 and I have put the
| kernel-file into /boot as uImage-GTA02.bin (yes I renamed it)
Sounds good.
| Then I powerdown my FR (battery out), put the battery back in and press
| power hold it down and press AUX.
You shouldn't need to press AUX.
| 2 lines are shown s3c2410_udc: debugfs dir creation failed -19
| power_supply bat: driver faild to report 'status' properly
It has booted "a" kernel, either the one from SD Card or fallen back to
NAND one. These are kernel messages.
| then the screen go's black and I have to press power and AUX again ->
| same lines appear again afther some time FR boots with flash image
|
| I folowed the wiki on Qi and Enabling console messages and Put a
| "rootdelay=" in append-GTAXX like so:
This append-GTAXX would be append-GTA02 in this case, just making sure.
| But.... no starting up from SD.
Sounds like you are actually starting up from somewhere just not getting
all the way.
- -Andy
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.9 (GNU/Linux)
Comment: Using GnuPG with Fedora - http://enigmail.mozdev.org
iEYEARECAAYFAklJZqIACgkQOjLpvpq7dMpEjQCeOiKa3Qu5sXhNGvGYmBuJYKab
QRgAnRIwpR3hryjE5Nj9HIJ1TY2nGTeh
=1mPX
-----END PGP SIGNATURE-----
More information about the community
mailing list