[2008.12] Help with Om.2008.12 on microsd

Andy Green andy at openmoko.com
Tue Dec 30 15:26:55 CET 2008


-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

Somebody in the thread at some point said:
| Em Sab, Dezembro 27, 2008 04:06, Kosa escreveu:
|> I've been trying to boot 2008.12 from a microsd but it just can't.
|> It starts booting but then it stops with an "Only GTA01 hardware
|> supported by ASoc driver" message.
|
| Happens to me also, but after that message I also have the following
| messages (not sure if they change from boot to boot):
|
| Unknown HZ value! (87) Assume 100.
| mount: special device /dev/mmcblkp01 does not exist
| ALSA: restoring mixer settings...
| Configuring network interfaces... /usr/sbin/alsactl: load_state:1327: No
| soundcards found...
| ADDRCONF(NETDEV_UP): usb0: link is not ready
| done.
|
| I can shutdown by holding the power button.
| I have FDOM in the same card and it works fine.

I was just meddling with this in NAND, I believe that "ro" on the kernel
commandline is fatal for startup of 2008.12.  When I removed it from Qi,
2008.08 started up OK.

So check your U-Boot env if you're using that for "ro", or try adding rw
to /boot/append-GTA02 if you are on SD Card and Qi.

It's pretty common to boot with rootfs ro initially...

- -Andy
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.9 (GNU/Linux)
Comment: Using GnuPG with Fedora - http://enigmail.mozdev.org

iEYEARECAAYFAklaL68ACgkQOjLpvpq7dMpdZwCfY23A6BvOiEu/OQx2bRnJh3A5
cJkAn2Mu/MbFjCdP9MIcdIqWAMpeHCYD
=Nm0M
-----END PGP SIGNATURE-----




More information about the community mailing list