using openocd
andi
andi.platschek at gmail.com
Thu Sep 11 17:47:32 CEST 2008
Hypnotize wrote:
> I have tried that to and get the same error messages! :(
Hi!
I go the debug board working the first time just a minute ago, but I had
the same errors.
Make sure, you have the flat flexible cable between debug board and
freerunner completely plugged into
the small connector on the freerunner.
This solved my problems ;-)
andi
>
> On Sun, Sep 7, 2008 at 3:52 AM, Holger Freyther <zecke at openmoko.org
> <mailto:zecke at openmoko.org>> wrote:
>
> On Sunday 07 September 2008 02:22:40 Hypnotize wrote:
> > Hi,
> >
> > I cant get openocd working (with Debug Board v3 and GTA02), I
> just get this
> > error message:
> >
> > $ openocd -f /etc/openocd/openocd.conf
> > Info: openocd.c:84 main(): Open On-Chip Debugger (2007-01-31
> 12:00 CET)
> > Error: ft2232.c:1351 ft2232_init(): unable to open ftdi device:
> > ftdi_usb_reset failed
>
> sudo openocd?
>
> z.
>
> _______________________________________________
> Openmoko community mailing list
> community at lists.openmoko.org <mailto:community at lists.openmoko.org>
> http://lists.openmoko.org/mailman/listinfo/community
>
>
> ------------------------------------------------------------------------
>
> _______________________________________________
> Openmoko community mailing list
> community at lists.openmoko.org
> http://lists.openmoko.org/mailman/listinfo/community
>
More information about the community
mailing list