fixing bug #1024 successful reports?

Bernd Prünster bernd.pruenster at gmail.com
Mon Aug 10 13:07:10 CEST 2009


Bartłomiej Zimoń schrieb:
> Dnia 10 sierpnia 2009 12:53 Bernd Prünster <bernd.pruenster at gmail.com> napisał(a):
>
>   
>> Paul Fertser schrieb:
>>     
>>> Bernd Prünster <bernd.pruenster at gmail.com> writes:
>>>
>>>   
>>>       
>>>> i treid to remove the can from the modem, but there is this other small 
>>>> pbc ontop of it that seems to be glued and connected to the mainboard 
>>>> through a connector plug.
>>>> my question: how to remove the can without damagin anything? (there is 
>>>> this metal mesh which is glued on aswell , but that wont be a problem)
>>>>     
>>>>         
>>> Simply slowly pull the wlan board, it unglues easily. Be careful
>>> dismounting the can, better spend more time on it. Just pull it a bit
>>> with a pin-pointed knife in every reasonable place, eventually it will
>>> come off.
>>>
>>> Good luck!
>>>
>>>   
>>>       
>> I DID IT!!! without smd capacitor
>> disassembling until the modem circuit si uncovered is a real bitch! took 
>> ma over an hour to get the can off!
>> the good part: you dont need an smd capacitor!!!
>> you need a capacitor which is small enough to fit in the gsm antenna and 
>> some of these lacquer wires (which are used in unductor coils)
>> solder a wire to c1009 (+) the lacquer wire easyli fits through the can 
>> even when colosed, colder it to the capacitor (+) solder another wire to 
>> gnd of the capacitor
>> solder this wire anywhere where you can find gnd (i used the drilled 
>> holes at teh edge od teh mainboard)
>> place the capacitor in teh gsm antenna, close everything and you are 
>> done, no smd capacitor needed, no smd soldering station needed.
>> it works!!!
>> standbytime now is 100 hours which means for me 2 and a half day of 
>> typically phone usage total uptime till i need to charge.
>>
>>     
>
> Good job!
>
> I just want to ask You about some nice photos of this wire/fix :>
>
> Best regards
> Bartlomiej Zimon
>
>
>   
can post photos in the next days (need to fix the fix a little and also 
need to find the battery for my camera) ( but i won't open up the can again)




More information about the community mailing list