fixing bug #1024 successful reports?

Paul Fertser fercerpav at
Mon Aug 10 18:01:01 CEST 2009

Bernd Prünster <bernd.pruenster at> writes:
> i attatched a pic describing how i did it.
> basically solder a lacquer wire to c1009's (+) wich you will fit
> through the shielding can so you can add another c in parallel which
> can be any kind of tht electrolyte capacitor small enought to fit in
> the gsm antenna. 

Fit in the gsm antenna? Do you mean fit under the gsm shield?

And using ceramic cap is recommended because low ESR is needed and
electrolitic caps can't provide that. If you connect your electrolitic
cap in parallel with the original one (as you did) then you're
probably ok but nevertheless i recommend to use ceramic. Also shield
itself is connected to the GND plane so i wouldn't go that far for a

Be free, use free ( software!
mailto:fercerpav at

More information about the community mailing list