QtMoko - v11 - WiFi take 2

[Torfinn Ingolfsen]

I did another test with wpa_supplicant manually.
This time, I looked more closely at the output, and noticed it said
"authentication timeout". Duh!
I checked my passphrase in wpa_supplicant.conf - one characyter had the
wrong case.

It works now:
neo:~# ifconfig eth0
eth0      Link encap:Ethernet  HWaddr 00:12:cf:8e:e4:11
          inet addr:10.1.161.6  Bcast:10.1.255.255  Mask:255.255.0.0
          inet6 addr: fe80::212:cfff:fe8e:e411/64 Scope:Link
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:743 errors:0 dropped:0 overruns:0 frame:0
          TX packets:193 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000
          RX bytes:571745 (558.3 KiB)  TX bytes:17229 (16.8 KiB)

neo:~# iwconfig eth0
eth0      AR6000 802.11g  ESSID:"kg4"
          Mode:Managed  Frequency:2.417 GHz  Access Point:
00:0F:66:51:AA:41
          Bit Rate=48 Mb/s   Tx-Power=15 dBm   Sensitivity=0/3
          Retry:on
          Encryption key:off
          Power Management:off
          Link Quality:194/94  Signal level:-157 dBm  Noise level:-96 dBm
          Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
          Tx excessive retries:7  Invalid misc:0   Missed beacon:0


Sorry for all the noise.
-- 
Regards,
Torfinn Ingolfsen
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.openmoko.org/pipermail/community/attachments/20090924/b956b2ef/attachment.htm