[GTA04] When is the next and more powerful openmoko releasing

Patryk Benderz Patryk.Benderz at esp.pl
Tue Oct 26 11:21:54 CEST 2010


[cut]
> Our results so far (I can't share all of them):
> 
> STL + Silicone moulds: 2000 EUR setup + 50 EUR each every 100 units
> Injection Moulds: 25000 EUR setup + 20 EUR per unit
> 3D-Printing: no setup, 400 EUR every unit (quality doubtful)
> Milling from ABS block: no setup, 500 EUR every unit
> 
> So 1-10 units does not come below 250 EUR. 100 units may come to 70 EUR.
> 1000 units to 45 EUR. 10k to 22.50 EUR. You see the volume effect and
> clear preference of injection moulds. Which also give best quality...
Could you estimate how many units do you want to produce?
[cut]
-- 
Patryk "LeadMan" Benderz
Linux Registered User #377521
()  ascii ribbon campaign - against html e-mail 
/\  www.asciiribbon.org   - against proprietary attachments




More information about the community mailing list