QtMoko Virtual Memory
Patryk.Benderz at esp.pl
Wed Sep 1 11:12:11 CEST 2010
Dnia 2010-09-01, śro o godzinie 10:50 +0200, Nashvin Gangaram pisze:
Hi, this question should go to support at lists.openmoko.org
> I was just experimenting the other day, trying to configure my Neo
> Freerunner with QtMoko v24 to use Virtual Memory. I created a swap
> partition on my MicroSDHC Card, using GParted on PC. I notice than on
> startup, there is something like a "Activating Swap Configuration...
> failed" message. So, I just had a couple of questions:
> * Is it possible for QtMoko to use a swap partition on the SD
> * How can this be done?
AFAIR, you can set this in /etc/fstab as /dev/mmcblk0p4
> * Does swap cause a significant performance increase with
IMHO, just a little performance gain. If you use logging, set /var/log
to your uSD.
Patryk "LeadMan" Benderz
Linux Registered User #377521
() ascii ribbon campaign - against html e-mail
/\ www.asciiribbon.org - against proprietary attachments
Email secured by Check Point
More information about the community