<div dir="ltr">Hello,<br><br>My Freerunner fails to recognize the SD card. There are no /dev/mmc* named devices in the system. I have 2007.2 image upgraded with opkg from factory image.<br><br>Revelant part of dmesg:<br><br>
root@om-gta02:~# dmesg | grep -E "glamo|mmc"<br>glamo3362 glamo3362.0: Detected Glamo core 3650 Revision 0002 (49119232Hz CPU / 81887232Hz Memory)<br>glamo3362 glamo3362.0: Glamo core now 49119232Hz CPU / 81887232Hz Memory)<br>
glamo-spi-gpio glamo-spi-gpio.0: registering c0373838: jbt6k74<br>glamo-mci glamo-mci.0: glamo_mci driver (C)2007 Openmoko, Inc<br>glamo-mci glamo-mci.0: probe: mapped mci_base:c8864400 irq:0.<br>glamo-mci glamo-mci.0: glamo_mci_set_ios: power down.<br>
glamo-mci glamo-mci.0: initialisation done.<br>mmc_set_power(power_mode=1, vdd=20<br>glamo-mci glamo-mci.0: powered (vdd = 20) clk: 0kHz div=255 (req: 0kHz). Bus width=0<br>glamo-mci glamo-mci.0: powered (vdd = 20) clk: 195kHz div=255 (req: 195kHz). Bus width=0<br>
glamo-mci glamo-mci.0: powered (vdd = 20) clk: 195kHz div=255 (req: 195kHz). Bus width=0<br>glamo-mci glamo-mci.0: powered (vdd = 20) clk: 195kHz div=255 (req: 195kHz). Bus width=0<br>glamo-mci glamo-mci.0: Error after cmd: 0x120<br>
glamo-mci glamo-mci.0: Error after cmd: 0x8120<br>glamo-mci glamo-mci.0: Error after cmd: 0x120<br>glamo-mci glamo-mci.0: Error after cmd: 0x8120<br>glamo-mci glamo-mci.0: Error after cmd: 0x120<br>glamo-mci glamo-mci.0: Error after cmd: 0x8120<br>
glamo-mci glamo-mci.0: Error after cmd: 0x120<br>glamo-mci glamo-mci.0: Error after cmd: 0x8120<br>glamo-mci glamo-mci.0: Error after cmd: 0x120<br>glamo-mci glamo-mci.0: Error after cmd: 0x8120<br>mmc_set_power(power_mode=0, vdd=0<br>
glamo-mci glamo-mci.0: glamo_mci_set_ios: power down.<br><br>Also I've seen a line like this:<br><br>mmc0: error -110 whilst initialising sd card<br><br>Regards,<br><br>Marek Materzok<br></div>