andy-tracking
Sander van Grieken
sander at 3v8.net
Wed Jan 7 13:10:14 CET 2009
On Wednesday 07 January 2009 12:51:33 Andy Green wrote:
> Somebody in the thread at some point said:
> | In the end I only had to change bitbake's conf/local.conf and include
>
> these
>
> | lines to move over to 2.6.28 + comaptible frameworkd:
> |
> | PREFERRED_PROVIDER_virtual/kernel = "linux-openmoko-devel"
> | PREFERRED_PROVIDER_frameworkd = "frameworkd-devel"
>
> That sounds cool.
>
> | - wifi seems to be toggled by each suspend/resume cycle. After boot
>
> wifi is
>
> | enabled (even though the interface is not marked 'auto' in
> | /etc/network/interfaces). After the first suspend cycle it's disabled,
>
> the
>
> | next cycle it's enabled again, etc.
>
> Thanks for the report about it, what does enabled or disabled mean for
> Wifi? Say if it is in "disabled" situation, what does that look like?
eth0 is up but lost its IP, wireless is not associated.
An 'ifup eth0' immediately re-establishes the connection..
root at om-gta02:~# ifconfig
eth0 Link encap:Ethernet HWaddr 00:12:CF:8E:xx:xx
inet6 addr: fe80::212:cfff:fe8e:e2b0/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:3 errors:0 dropped:0 overruns:0 frame:0
TX packets:5 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:230 (230.0 B) TX bytes:370 (370.0 B)
root at om-gta02:~# iwconfig
lo no wireless extensions.
usb0 no wireless extensions.
pan0 no wireless extensions.
eth0 AR6000 802.11g ESSID:""
Mode:Managed Bit Rate=1 Mb/s Tx-Power=0 dBm Sensitivity=0/3
Retry:on
Encryption key:off
Power Management:on
Link Quality:0/94 Signal level:-95 dBm Noise level:-96 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
grtz,
Sander
More information about the devel
mailing list