SPI signal accessibility?

Heilpern, Mark mark.heilpern at authentec.com
Fri Aug 3 22:30:19 CEST 2007

I didn't see an email list that seemed appropriate so....


Does anyone know how I can access the SPI signals on my Neo? The wiki's
v3 debug board page implies that these signals are brought out through
the debug header and will be made accessible on the v3 board, however
the advanced kit apparently is shipping with the v2 debug board. (I
don't know how to verify this; my debug board has no version indication
that I recognize.)


If SPI is actually brought through the debug header, all I really need
is a pin-out list for that header (and a really small soldering iron!).
As I'll need a few more signals beyond SPI, having such a list would be
great - but I don't see that documented on the wiki. Does anyone know if
that header is documented?




NOTE: The information in this message is intended for the personal and confidential use
of the designated recipient(s) named above. To the extent the recipient(s) is/are bound
by a non-disclosure agreement, or other agreement that contains an obligation of
confidentiality, with AuthenTec, then this message and/or any attachments shall be
considered confidential information and subject to the confidentiality terms of that
agreement.  If the reader of this message is not the intended recipient named above, you
are notified that you have received this document in error, and any review, dissemination,
distribution or copying of this message is strictly prohibited. If you have received this
document in error, please delete the original message and notify the sender immediately.
Thank you.

AuthenTec, Inc.  http://www.authentec.com

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.openmoko.org/pipermail/device-owners/attachments/20070803/a605ce83/attachment-0001.htm

More information about the device-owners mailing list