GSM-noise "buzz" issue

[Angus Ainslie]

On Fri, Oct 31, 2008 at 2:26 PM, Joerg Reisenweber <joerg at openmoko.org>wrote:

> Sorry for any faults or ambiguities! Once again:
>
> change R4303 (oh-three) [0R, MIC4301:2 to GND] to 2k2
>
> R4304 (oh-four) is not in the published schem [any more], it's obviously
> been
> replaced in schematics by C4306 [NC, MIC4301:1 to GND]. However you may
> find
> R4304 in component placement diagram (you won't find C4306 there!). It's
> the
> two empty pads left side of the component array left to mic. Symmetric to
> R4303.
>
>
> If you want to retrofit C4306 with a huge capacitor, you could use the
> empty
> pads of R4304 to connect it. You also *have* to make the R4303 0->2k2
> change,
> otherwise mic signal is shorted by this capacitor and you won't see decent
> signal on mixer input.
>
> HTH
> cheers
> jOERG
>

That's better. For now I stayed with the 1uF. I might change back to 100uF
on Monday.

While I had the phone open I took a better picture of the bead hack.

http://handheldshell.com/DSCN0392.JPG
http://handheldshell.com/DSCN0392_small.JPG

-- 
Angus Ainslie
http://www.handheldshell.com/
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.openmoko.org/pipermail/hardware/attachments/20081031/a634e24f/attachment-0001.htm