my buzz fix method
joerg at openmoko.org
Fri Mar 27 03:34:00 CET 2009
Am Fr 27. März 2009 schrieb Anthony Clearn:
> Here is my attempt http://anyotherkey.googlepages.com/c
> AFAIK I made a few mistakes:
> 1 I could have used a smaller sized 100uF cap
> 2 I could have used thinner wire, I picked up the wrong spool and didn't
> 3 I shouldn't have tried to open a solder bridge on a 0402 component with a
relatively large iron.
> I'm looking into the low volume of my voice on calls, I've only read up
briefly on what could be the cause. I can't be certadinin it wasn't always so
low! I am looking through the posts to figure this out from other peoples
muchas gracias for this really cool photo footage. Close to real live. It's
been all the same when I started to try and do that.
Regarding your low volume: did you check R4303? (It's the one below the two NC
pads and right side to C4303, the one you borked and replaced. It's clearly
mentioned in my SOP paper) R4303 is not mentioned in your story if I didn't
miss anything. Usually it's 0R and it's amazing you get *any* signal at all
from mic if you haven't replaced it by a ~2k2k (probably anything between
400Ohms and 3k will do, though I learnt by your report even a 0R will do at
least partially :D ).
Please keep on reporting this way, and don't hesitate to ask me for whatever
kinda help you might need. I have a few spare devices for emergencies ;-)
Your report is considered *very* encouraging by me. It shows how much you can
deviate from SOP recommendations and still you get better results than MP
device. Also it shows everybody is encountering some sort of same problems
when doing this first time, and there's a way to recover from those.
a heartly cheers
-------------- next part --------------
A non-text attachment was scrubbed...
Name: not available
Size: 197 bytes
Desc: This is a digitally signed message part.
Url : http://lists.openmoko.org/pipermail/hardware/attachments/20090327/e14d9fd7/attachment.pgp
More information about the hardware