Getting our batteries to charge
Harald Welte
laforge at openmoko.org
Tue Apr 3 18:37:42 CEST 2007
On Tue, Apr 03, 2007 at 11:35:46AM -0400, Richard A. Smith wrote:
> Heh.. All we got was Mako's phone(s) and then the debug board you sent
> later. So we don't have that device to trouble us.
ok. I keep forgetting that you are pre-phase-0 ;)
> Will do. Now that I know it _should_ work I'll start sniffing. Any
> recommendations for connecting to the battery such that I can get
> inline? I suppose I could tack on some small wires if I'm quick with
> the iron. Do I have to hook up the one-wire signal as well?
the third pin is actually just a NTC resistor connected to ground.
Should have 10kOhms at 25 celsius. It should work even without that
resistor connected, but just to make sure I recommend connecting the NTC
- after all it's a safeguard against battery overtemp.
I'll ask FIC to send you a couple of more batteries. Also, they should
be able to send you the remaining 'kit', i.e. stylus, lanyard, etc.
--
- Harald Welte <laforge at openmoko.org> http://openmoko.org/
============================================================================
Software for the world's first truly open Free Software mobile phone
More information about the neo1973-hardware
mailing list