[AR6000] Openmoko driver for OMAP3 ( TI )

[Michael Trimarchi]

dongas wrote:
> Dear Michael,
>
> Can you help have a look at on my issue.
> Now i really need some advices.
> No more effective methods i can find. :-(
> http://lists.openmoko.org/nabble.html#nabble-td2591890%7Ca2593593
> (a bit similar with this issue)
>
> Thanks
>
> Regards
> Dongas
>   
Ok there is an & 0xff. Suppose that the credits are send 0xAAxx and the 
upper
part is more important. Can you print all the value of the credit 
instead the low part?
Michael
> 2009/4/8 Michael Trimarchi <trimarchi at gandalf.sssup.it>:
>   
>> Hi all
>> dongas wrote:
>>     
>>> 2009/4/6 OMAP3 <vincent.del.medico at gmail.com>:
>>>       
>>>> So, I used ar6k driver for firmware 1.3, applied your patches for Linux
>>>> SDIO, and had to adapt a few things, but not that much. Nevertheless, the
>>>> card still doesn't answer while init :
>>>> mmc0: new SDIO card at address 0001
>>>> eth0: link down
>>>> ar6000_available
>>>> BMI Get Target ID: Enter (device: 0xc048dac8)
>>>> BMI Communication timeout
>>>> Unable to write to the device
>>>>
>>>>         
>>> It seems you got the same issue as i got. The driver failed to read
>>> the Target info of card.
>>> I still have no ideas on why that.
>>> But something strange is that from the log in your first mail, it
>>> looks you already successfully got it as follows:
>>> "BMI Get Target Info: Exit (ver: 0x1301000e type: 0x1) Block Size Set:
>>> 128 (target "
>>> But the driver can not get it now.
>>> Is there any big difference between the two version of code or HW?
>>>
>>> Regards
>>> Dongas
>>>
>>>
>>>       
>> Anyone has the datasheet, maybe the offset address are different.
>>
>> Michael
>>
>>     
>
>