g_ether code 10 error using linux kernel 2.6.28 on SMDK2440

[Andy Green]

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

Somebody in the thread at some point said:
| Hello All,
|
| I am testing USB RNDIS module on SMDK2440 using linux kernel 2.6.28.
|
| First using modprobe g_ether command to load the module and then
connect the
| USB cable to my Winxp host. Winxp can find the device
| (I am using the usb.inf in linux-2.6.28\Documentation\usb folder),
however
| Winxp
| reports the "code 10" error message during the driver installation
process.
| I cannot
| use the RNDIS adapter on Winxp.
|
| I have tested the g_file_storage module using the same environment
| successfully. It seems
| that there is a problem with the g_ether module. Below is the debug log
| after I define DEBUG in etehr.c file.
|
| Any suggestions will be appreciated

Ethernet over USB has been broken for some periods (a least twice) in
the past in upstream kernel.  If you're building our tree, your best bet
is to try andy-tracking HEAD where it seems OK.

- -Andy
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.9 (GNU/Linux)
Comment: Using GnuPG with Fedora - http://enigmail.mozdev.org

iEYEARECAAYFAkmkvGUACgkQOjLpvpq7dMrNxwCeNZPjINnV1u5+cGs8SRPPgwhS
p/wAn1SYZtPlzT8bMTX0SdBK23mDMjt1
=/+bp
-----END PGP SIGNATURE-----