[PATCH] ARM: gta02: Add gpio bank B quirk for hardware revision 5 and earlier

Lars-Peter Clausen lars at metafoo.de
Thu Sep 24 19:41:54 CEST 2009


On hardware revision 5 and earlier the leds found on the gta02 are missing a
resistor and reading their gpio pin status will always return 0. So we have to
shadow the led states in software. This is done by "hijacking" the gpio accessor
functions for bank B.

Signed-off-by: Lars-Peter Clausen <lars at metafoo.de>
---
 arch/arm/mach-s3c2442/mach-gta02.c |   64 ++++++++++++++++++++++++++++++++++-
 1 files changed, 62 insertions(+), 2 deletions(-)

diff --git a/arch/arm/mach-s3c2442/mach-gta02.c b/arch/arm/mach-s3c2442/mach-gta02.c
index 7629371..baba72e 100644
--- a/arch/arm/mach-s3c2442/mach-gta02.c
+++ b/arch/arm/mach-s3c2442/mach-gta02.c
@@ -89,6 +89,7 @@
 #include <plat/pm.h>
 #include <plat/udc.h>
 #include <plat/gpio-cfg.h>
+#include <plat/gpio-core.h>
 #include <plat/iic.h>
 
 static struct pcf50633 *gta02_pcf;
@@ -607,8 +608,8 @@ static struct gpio_led_platform_data gta02_gpio_leds_pdata = {
 };
 
 static struct platform_device gta02_leds_device = {
-	.name = "leds-gpio",
-	.id   = -1,
+	.name	= "leds-gpio",
+	.id		= -1,
 	.dev = {
 		.platform_data = &gta02_gpio_leds_pdata,
 	},
@@ -674,11 +675,70 @@ static void gta02_poweroff(void)
 	pcf50633_reg_set_bit_mask(gta02_pcf, PCF50633_REG_OOCSHDWN, 1, 1);
 }
 
+/* On hardware rev 5 and earlier the leds are missing a resistor and reading
+ * from their gpio pins will always return 0, so we have to shadow the
+ * led states software */
+static unsigned long gpb_shadow;
+extern struct s3c_gpio_chip s3c24xx_gpios[];
+
+static void gta02_gpb_set(struct gpio_chip *chip,
+				unsigned offset, int value)
+{
+	void __iomem *base = S3C24XX_GPIO_BASE(S3C2410_GPB(0));
+	unsigned long flags;
+	unsigned long dat;
+
+	local_irq_save(flags);
+
+	dat = __raw_readl(base + 0x04) | gpb_shadow;
+	dat &= ~(1 << offset);
+	gpb_shadow &= ~(1 << offset);
+	if (value) {
+		dat |= 1 << offset;
+		switch (offset) {
+		case 0 ... 2:
+			gpb_shadow |= 1 << offset;
+			break;
+		default:
+			break;
+		}
+	}
+	__raw_writel(dat, base + 0x04);
+
+	local_irq_restore(flags);
+}
+
+static int gta02_gpb_get(struct gpio_chip *chip, unsigned offset)
+{
+	void __iomem *base = S3C24XX_GPIO_BASE(S3C2410_GPB(0));
+	unsigned long val;
+
+	val = __raw_readl(base + 0x04) | gpb_shadow;
+	val >>= offset;
+	val &= 1;
+
+	return val;
+}
+
+static void gta02_hijack_gpb(void)
+{
+/* Uncomment this, once support for S3C_SYSTEM_REV_ATAG has been merged
+ * upstream.
+	if (S3C_SYSTEM_REV_ATAG > GTA02v5_SYSTEM_REV)
+		return;
+*/
+
+	s3c24xx_gpios[1].chip.set = gta02_gpb_set;
+	s3c24xx_gpios[1].chip.get = gta02_gpb_get;
+}
+
 static void __init gta02_machine_init(void)
 {
 	/* Set the panic callback to make AUX LED blink at ~5Hz. */
 	panic_blink = gta02_panic_blink;
 
+	gta02_hijack_gpb();
+
 	s3c_pm_init();
 
 #ifdef CONFIG_CHARGER_PCF50633
-- 
1.5.6.5




More information about the openmoko-kernel mailing list