SSH into Freerunner
shawn sullivan
shelbydz at gmail.com
Thu Jul 17 04:40:42 CEST 2008
Correct. And when I run ifconfig afterwards I get:
usb0 Link encap:Ethernet HWaddr ee:8e:94:93:61:96
inet addr:192.168.1.200 Bcast:192.168.1.255 Mask:255.255.255.0
inet6 addr: fe80::ec8e:94ff:fe93:6196/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:15 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:2733 (2.6 KB)
Steven ** wrote:
> I assume the ifconfig command doesn't give any errors when you run it.
> I know I had to run it with sudo for it to work.
>
> -Steven
>
> On Wed, Jul 16, 2008 at 9:30 PM, shawn sullivan <shelbydz at gmail.com> wrote:
>> Thanks Steven. I've actually tried both variations with the same
>> results. I thought maybe my system was getting confused w/ the
>> 192.168.0.200.
>>
>> Steven ** wrote:
>>> Not sure if it makes a difference, but everyone else uses
>>> 192.168.0.200 and 192.168.0.202. You've got a 1 instead of a 0.
>>>
>>> -Steven
>>>
>>> On Wed, Jul 16, 2008 at 9:20 PM, shawn sullivan <shelbydz at gmail.com> wrote:
>>>> I've been unable to SSH into my phone. I did:
>>>>
>>>> ifconfig usb0 192.168.1.200 netmask 255.255.255.0
>>>>
>>>> but when I do:
>>>> ssh root at 192.168.1.202
>>>>
>>>> it can't find the host. i've tried disabling the firewall; no dice.
>>>> Here's my routing table:
>>>>
>>>> Kernel IP routing table
>>>> Destination Gateway Genmask Flags MSS Window irtt
>>>> Iface
>>>> 192.168.0.0 * 255.255.255.0 U 0 0 0
>>>> eth0
>>>> link-local * 255.255.0.0 U 0 0 0
>>>> eth0
>>>> default dslmodem.domain 0.0.0.0 UG 0 0 0
>>>> eth0
>>>>
>>>> It appears that there is no route to the USB port, but I'm not sure how
>>>> to enable that. Can someone help me out? I'm running Ubuntu. I did
>>>> verify that the phone is on USB0, but I cannot get any results when I
>>>> ping the IP address.
>>>>
>>>> thx
>>>> . . .shawn
>>>>
More information about the support
mailing list