QtExtended 4.4.2 : GPRS
Bartłomiej Zimoń
uzi18 at o2.pl
Tue Nov 4 17:34:03 CET 2008
One step closer . this connect script is working well (need tu update always after change by gui) :
TIMEOUT 15
"" "\K\K\K\d+++ATH"
OK-AT-OK ATZ
OK ATE1
ABORT BUSY
ABORT DELAYED
ABORT "NO ANSWER"
ABORT "NO DIALTONE"
ABORT VOICE
ABORT ERROR
ABORT RINGING
TIMEOUT 60
OK AT+CFUN=1
ERROR AT+CPIN="here your pin" # but here after 1st connect i have OK!! and abort :(
OK AT+COPS
OK AT+CGDCONT=1,"IP","mms"
OK ATD*99#
CONNECT ''
now ppd connects
but have bad (default) local and remote addresses - is it possible ?
local 10.64.64.64.64
remote 10.112.112.112
ppp0 Link encap:Point-to-Point Protocol
inet addr:10.64.64.64 P-t-P:10.112.112.112 Mask:255.255.255.255
UP POINTOPOINT RUNNING NOARP MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:2 errors:0 dropped:297 overruns:0 carrier:0
collisions:0 txqueuelen:3
RX bytes:0 (0.0 B) TX bytes:118 (118.0 B)
# route -n
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
10.112.112.112 0.0.0.0 255.255.255.255 UH 0 0 0 ppp0
192.168.0.0 0.0.0.0 255.255.255.0 U 0 0 0 usb0
0.0.0.0 10.112.112.112 0.0.0.0 UG 0 0 0 ppp0
root at om-gta02:~# ping 10.112.112.112
PING 10.112.112.112 (10.112.112.112): 56 data bytes
--- 10.112.112.112 ping statistics ---
7 packets transmitted, 0 packets received, 100% packet loss
What could be wrong ?
_________________
Regards
Bartłomiej Zimoń
More information about the community
mailing list