QtExtended 4.4.2 : GPRS

Bartłomiej Zimoń uzi18 at o2.pl
Thu Nov 6 15:47:40 CET 2008


Tuesday 04 of November 2008 17:34:03 Bartłomiej Zimoń napisał(a):
> One step closer . this connect script is working well  (need tu update always after change by gui) :
> 
> TIMEOUT 15
> "" "\K\K\K\d+++ATH"
> OK-AT-OK ATZ
> OK ATE1
> ABORT BUSY
> ABORT DELAYED
> ABORT "NO ANSWER"
> ABORT "NO DIALTONE"
> ABORT VOICE
> ABORT ERROR
> ABORT RINGING
> TIMEOUT 60
> OK AT+CFUN=1
> ERROR AT+CPIN="here your pin"   # but here after 1st connect i have OK!! and abort :(
> OK AT+COPS
> OK AT+CGDCONT=1,"IP","mms"
> OK ATD*99#
> CONNECT ''
> 
> now ppd connects  
> but have bad (default) local and remote addresses  - is it possible ?
> local 10.64.64.64.64
> remote 10.112.112.112
> 
> ppp0      Link encap:Point-to-Point Protocol
>           inet addr:10.64.64.64  P-t-P:10.112.112.112  Mask:255.255.255.255
>           UP POINTOPOINT RUNNING NOARP MULTICAST  MTU:1500  Metric:1
>           RX packets:0 errors:0 dropped:0 overruns:0 frame:0
>           TX packets:2 errors:0 dropped:297 overruns:0 carrier:0
>           collisions:0 txqueuelen:3
>           RX bytes:0 (0.0 B)  TX bytes:118 (118.0 B)
> 
> # route -n
> Kernel IP routing table
> Destination     Gateway         Genmask         Flags Metric Ref    Use Iface
> 10.112.112.112  0.0.0.0         255.255.255.255 UH    0      0        0 ppp0
> 192.168.0.0     0.0.0.0         255.255.255.0   U     0      0        0 usb0
> 0.0.0.0         10.112.112.112  0.0.0.0         UG    0      0        0 ppp0
> 
> root at om-gta02:~# ping 10.112.112.112
> PING 10.112.112.112 (10.112.112.112): 56 data bytes
> 
> --- 10.112.112.112 ping statistics ---
> 7 packets transmitted, 0 packets received, 100% packet loss
> 

Now even worst after 1-2h power off i have this log after boot :
# tail -f  /tmp/qtopia-0/qpe-pppd-log-dialup1225707475
timeout set to 15 seconds
send (\K\K\K\d+++ATH^M)
expect (OK)
alarm
send (AT^M)
expect (OK)
alarm
Failed
Connect script failed


_________________
Regards
Bartłomiej Zimoń




More information about the community mailing list