Zhone doesn't show my contacts and messages after restart

Michael 'Mickey' Lauer mickey at openmoko.org
Wed Nov 26 21:36:02 CET 2008


Am Monday 24 November 2008 21:10:33 schrieb Paul Fertser:
> Hi,
>
> "Michael 'Mickey' Lauer" <mickey at openmoko.org> writes:
> > Am Monday 24 November 2008 13:33:54 schrieb Paul Fertser:
> >> I think i know what happens. If i restart Zhone without restarting
> >> frameworkd it never receives ReadyStatus signal from
> >> org.freesmartphone.GSM.SIM because sim was ready long ago it
> >> started.
> >
> > This should no longer be a problem as nowadays, if the last GSM user
> > vanishes from the bus, the GSM resource (hence the modem) gets shutdown
> > completely.
>
> Yes, moreover after any network status change Zhone will try to reread
> the contacts and messages lists. But the problem is that
> org.freesmartphone.GSM.SIM.GetSimReady return 0 after Zhone
> restart.

Which should no longer happen, if zhone is the only user of the GSM resource.

> According to log the modem doesn't send a %CSTAT status,
> though it was resetted by ATZ and answered OK on AT%CSTAT=1 request.
>
> I can send a log that shows that after a minute after ATZ the modem
> still didn't send a %CSTAT report. It didn't send it later as well (or
> else the icons in Zhone would have become highlighted).
>
> As the exact documentation on %CSTAT is unavailable (thank you, TI), i
> looked it up in Enfora's. It says that the %CSTAT codes will be
> delivered only after power on. If it is really the case with calypso
> it is no surprise that we never get SimReady signal as we don't
> power-cycle the modem (ATZ seems to be not equivalent, and we can't do
> $RESET). So it seems that %CSTAT should be avoided altogether...

It's a question of alternatives. I don't think hammering the modem with 
read/write contact requests until it stops answering with 'SIM busy' is 
better than using %CSTAT.



-- 
:M:




More information about the community mailing list