using openocd

[Neng-Yu Tu (Tony Tu)]

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

Hi Lynn-

> I was wondering if anyone was using the Neo1973 (GTA01v4) with Debug
> board v3. I used the openocd.cfg available on the wiki and I get this
> problem:
> Info:    openocd.c:82 main(): Open On-Chip Debugger (2006-08-01 12:00 CEST)
> Info:    configuration.c:50 configuration_output_handler(): Command
> ft2232_device_desc not found
> Info:    configuration.c:50 configuration_output_handler(): Command
> ft2232_layout not found
> Info:    configuration.c:50 configuration_output_handler(): Command
> ft2232_vid_pid not found
> Error:   jtag.c:1219 jtag_init(): No valid jtag interface found (ft2232)
> 
> It seems like openocd is having some trouble with ft2232 because I don't
> see anything wrong with those commands.
> 

Does your openocd load neo1973 specific config? like tmp/openocd -f
tmp/openocd-debugv2.cfg

Usually it is because your USB vid/pid setting is not correct in the
config file(load the wrong config file)

Hope this helps.

=
- --
Neng-Yu Tu (Tony Tu)
Openmoko, Inc.
Support.

Some questions could be answered by reference following link:

Wiki - http://wiki.openmoko.org
Download - http://downloads.openmoko.org

Freerunner Introduction -
http://wiki.openmoko.org/wiki/Getting_Started_with_your_Neo_FreeRunner
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.9 (MingW32)
Comment: Using GnuPG with Mozilla - http://enigmail.mozdev.org

iEYEARECAAYFAki7c4MACgkQmV6sZhhBn29BwQCfSRPiSVTPKhPeUAGd1R6m0D80
1sIAn1dFiXdIuulTTCqYM6mmfPsRvjJD
=ubFB
-----END PGP SIGNATURE-----