Navit problem?

Hrabosh zbynecek at volny.cz
Sun Apr 10 19:36:00 CEST 2011


Sven Hartrumpf píše v So 09. 04. 2011 v 12:11 +0200:
> Hi.
> 
> Fri, 08 Apr 2011 21:26:31 +0200, pini wrote:
> >> I am trying Navit for the first time and followed these instructions:
> >> 
> >> http://wiki.openmoko.org/wiki/QtMoko#Navit_Installation
> >> 
> >> Works fine, but after the suggested reboot, I just see
> >> "Enter PIN the press Unlock" (no numbers field as usual).
> >> The screen and the buttons do not react in any way.
> 
> I had to flash again :-(
> 
> > IIUC qtmoko is based on Debian. Why not install
> 
> Because I trusted the Wiki page :-)
> Could someone knowledgable update the Navit section, please?
> (OK, _if_ I get Navit working (see below), I could do this myself.)
> 
> > Navit from the
> > appropriate Debian repository?
> 
> OK. I tried this now.
> 
> The following works without adjusting repositories:
> 
> apt-get install navit

I did the same. Also gpsd should be installed.

Then I installed Xglamo and Navit seems to run, but it is bigger than
the screen (I can!t see part of the Navit keyboard, etc.) and I don!t
have any Navit icon in QX.




> 
> When I started QX from the GUI I had to install an X server.
> Which one is recommended? (Xorg or Xglamo?)
> I tried both, but with no success (I saw Raptor install packages,
> but no error message; it could be that the root fs is full now).
> 
> So, I tried
> 
> apt-get install xserver-xorg
> 
> which worked, but starting xterm (or navit) from QX leads to:
> 
> "Unable to connect to X server"
> 
> Ciao
> Sven
> 
> _______________________________________________
> Openmoko community mailing list
> community at lists.openmoko.org
> http://lists.openmoko.org/mailman/listinfo/community
> 





More information about the community mailing list