Home-Brew IR port. Was - Please Ignore RS232 message. The
subject should read IrDA port... Sorry
Werner Almesberger
werner at openmoko.org
Fri May 11 19:05:21 CEST 2007
Alan Ide wrote:
> Again, all we need to make the home-brew IR work is either an open serial
> port, or to configure one of the GPIO ports as the TX line of a serial port.
All three UARTs of the 2410 are in use (one for GSM, the other two
for GPS data and handshake (*)). You can't assing the UART to random
GPIOs.
(*) I.e., the 2nd UART is not used, but its RX/TX pins are taken.
You could of course try to dual use some UART. I wonder why LIRC
requires a UART. Does it use it to generate the 38 kHz carrier ?
- Werner
--
_________________________________________________________________________
/ Werner Almesberger, Buenos Aires, Argentina werner at almesberger.net /
/_http://www.almesberger.net/____________________________________________/
More information about the openmoko-devel
mailing list