[AR6000] Openmoko driver for OMAP3 ( TI )
Michael Trimarchi
trimarchi at gandalf.sssup.it
Thu Apr 9 08:48:40 CEST 2009
Hi,
benson.dong wrote:
> On Wed, 08 Apr 2009 16:44:16 +0200, Michael Trimarchi
> <trimarchi at gandalf.sssup.it> wrote:
>
>> Sorry again,
>> I have a bit differnt code, do you pass the GetTargetInfo call,
>>
>> if not can you print the entire credit. Credit is a four byte, maybe
>> depend
>> in how the spi is configured MSB etc and the bus width. So it arrives
>> but it is invalid
>>
>>
>
> Sorry about my careless.
> I think i have posted a wrong link.
> My issue is here:
> http://lists.openmoko.org/nabble.html#nabble-td2548680
> However, it's a bit similar with OMAP3's issue.
> (If possible could you post in above thread?)
>
> I think i'm using the same code as you which is from Openmoko's lastest
> kernel 2.6.29.
> The issue is that ar6000 driver never passed the GetTargetInfo call.
> I'm sure that the Credit value read in host driver in low level is 0.
> So it will not cause by the "& 0xff".
>
Ok, because I can't try... I will take a look again to the code.
Michael
More information about the openmoko-kernel
mailing list