some question about Debug Board

[Andy Green]

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

Somebody in the thread at some point said:
| Hi xiangfu:
|
|> i receive a new debug board and the serial console is work.
|> yesterday i try to use openocd but it is not work.
|>
- --------------------------------------------------------------------------
|
|> Bus 002 Device 015: ID 0403:6010 Future Technology Devices
|> International, Ltd FT2232C Dual USB-UART/FIFO IC
|
| Your debug board is not programed or been cleaned eeprom, the USB ID is
| default FTDI ID 0403:6010
|
|> Unable to find FTDI devices under given vendor/product id: 0x1457/0x5118
|> Retrying with default FTDI id.
|> Used eeprom space: 102 bytes
|> FTDI write eeprom: 0
|> Writing to file: neo1973_debug_board_v2.eeprom
|> FTDI close: 0
|
| Same problem, it's not 0x1457/0x5118 anymore. so flashing fail.
|
| You could modify the openocd.cfg or openocd-debugv2.cfg file ,
| ftdi_vid_pid 0x0403 0x6010 make it work without refresh eeprom into
| correct USB ID.

Good job Tony answered, my experience is with exactly one rev2 debug
board that came from Willie with EEPROM set up so it's a much education
for me as you Xiangfu :-)

- -Andy
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.9 (GNU/Linux)
Comment: Using GnuPG with Fedora - http://enigmail.mozdev.org

iEYEARECAAYFAkjMzE4ACgkQOjLpvpq7dMoaogCfcIsCKLHzFPHQDSqUBPSboq3Q
rFIAoJMkHDM9DvoRFkdUyCqvX+oMFCao
=PQ5g
-----END PGP SIGNATURE-----