need sugestions

[Iurii]

rusolis wrote:
> 
> If you can connect the FR to your Linux box through usb, then you can use
> ssh and scp to copy and install stuff.
> 

i have connected my FR with the usb Cable and i started then 
ifconfig usb0 192.168.0.200 netmask 255.255.255.0

ifconfig
eth0      Link encap:Ethernet  HWaddr 00:14:2a:a9:4d:fb  
          UP BROADCAST MULTICAST  MTU:1500  Metric:1
          RX packets:10455 errors:0 dropped:0 overruns:0 frame:0
          TX packets:2131 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000 
          RX bytes:2273585 (2.1 MB)  TX bytes:208033 (203.1 KB)
          Interrupt:16 Base address:0xe400 

lo        Link encap:Local Loopback  
          inet addr:127.0.0.1  Mask:255.0.0.0
          inet6 addr: ::1/128 Scope:Host
          UP LOOPBACK RUNNING  MTU:16436  Metric:1
          RX packets:516 errors:0 dropped:0 overruns:0 frame:0
          TX packets:516 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0 
          RX bytes:25800 (25.1 KB)  TX bytes:25800 (25.1 KB)

usb0      Link encap:Ethernet  HWaddr 5a:01:10:2e:59:4d  
          inet addr:192.168.0.200  Bcast:192.168.0.255  Mask:255.255.255.0
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:109 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000 
          RX bytes:0 (0.0 B)  TX bytes:16042 (15.6 KB)

Then:
ssh 192.168.0.200
ssh: connect to host 192.168.0.200 port 22: Connection refused

am i missing any steps or doing smth wrong?
-- 
View this message in context: http://n2.nabble.com/need-sugestions-tp4036447p4036945.html
Sent from the Openmoko Support mailing list archive at Nabble.com.