[AR6000] Openmoko driver for OMAP3 ( TI )

[Michael Trimarchi]

Hi all
dongas wrote:
> 2009/4/6 OMAP3 <vincent.del.medico at gmail.com>:
>> So, I used ar6k driver for firmware 1.3, applied your patches for Linux SDIO, and had to adapt a few things, but not that much. Nevertheless, the card still doesn't answer while init :
>> mmc0: new SDIO card at address 0001
>> eth0: link down
>> ar6000_available
>> BMI Get Target ID: Enter (device: 0xc048dac8)
>> BMI Communication timeout
>> Unable to write to the device
>>
>
> It seems you got the same issue as i got. The driver failed to read
> the Target info of card.
> I still have no ideas on why that.
> But something strange is that from the log in your first mail, it
> looks you already successfully got it as follows:
> "BMI Get Target Info: Exit (ver: 0x1301000e type: 0x1) Block Size Set:
> 128 (target "
> But the driver can not get it now.
> Is there any big difference between the two version of code or HW?
>
> Regards
> Dongas
>
>
Anyone has the datasheet, maybe the offset address are different.

Michael