[AR6000] Openmoko driver for OMAP3 ( TI )

dongas dongas86 at gmail.com
Wed Apr 8 16:07:17 CEST 2009


Dear Michael,

Can you help have a look at on my issue.
Now i really need some advices.
No more effective methods i can find. :-(
http://lists.openmoko.org/nabble.html#nabble-td2591890%7Ca2593593
(a bit similar with this issue)

Thanks

Regards
Dongas

2009/4/8 Michael Trimarchi <trimarchi at gandalf.sssup.it>:
> Hi all
> dongas wrote:
>>
>> 2009/4/6 OMAP3 <vincent.del.medico at gmail.com>:
>>>
>>> So, I used ar6k driver for firmware 1.3, applied your patches for Linux
>>> SDIO, and had to adapt a few things, but not that much. Nevertheless, the
>>> card still doesn't answer while init :
>>> mmc0: new SDIO card at address 0001
>>> eth0: link down
>>> ar6000_available
>>> BMI Get Target ID: Enter (device: 0xc048dac8)
>>> BMI Communication timeout
>>> Unable to write to the device
>>>
>>
>> It seems you got the same issue as i got. The driver failed to read
>> the Target info of card.
>> I still have no ideas on why that.
>> But something strange is that from the log in your first mail, it
>> looks you already successfully got it as follows:
>> "BMI Get Target Info: Exit (ver: 0x1301000e type: 0x1) Block Size Set:
>> 128 (target "
>> But the driver can not get it now.
>> Is there any big difference between the two version of code or HW?
>>
>> Regards
>> Dongas
>>
>>
> Anyone has the datasheet, maybe the offset address are different.
>
> Michael
>



More information about the openmoko-kernel mailing list